It often happens as you are working on rebuilding or restoring some old iron, machine tool, etc that you come across a blind bearing in some machined pocket. These can be a real bear to remove, especially if as in the case of my 70’s era Trackmaster bulldozer it’s a nasty mess in need of restoration. You can see the blind bearing in the top middle of the photo below.
I looked for a puller tool, they make them but even cheap ones are still a bit pricey for a single pull. This bearing, like all of the others was trashed, so I knew I wasn’t going to be reusing it, and as such I went with the tride and true method. I’ll share with photos below the details of one of the best ways to get a stuck bearing out.
Summing up my favorite blind bearing removol trick in steps:
Make a threaded bushing for the ID of the bearing, or use a nut that fits close enough.
Place in or on the bearing with the threaded hole centered as best you can.
Weld in place, and let everything cool fully. (you don’t have to go nuts, three good spot welds spaced are usually enough)
After it cools, thread in a good quality bolt with some crease or oil on the threads
Start turning and let the screw press out your blind bearing.
This of course requires a welder, but many of the tools I looked at cost as much as a cheap HF welder. Go buy the welder, you will be happy you purchased it rather than a fancy one time use blind bearing removal tool.
Sharing some of my projects and what I've learned along the way